Table of Contents
Advertisement
Configuration in the WBM
• Egress: The outgoing data packets are copied and forwarded to the monitor port.
Note
The monitor port cannot be a trunk member port.
Firmware version 2.53 for the switch does not permit you to mirror a range of ports to a
monitor port.
Firmware version 2.53 for the switch does not permit you to choose between the different
source modes. By default, both incoming and outgoing data packets are copied and for-
warded to the monitor port.
10.4.6.2 Port Mirroring Setup
Parameter
Enable State
Source Port
Destination Port
10.4.7 Password
User name "admin" and password "wago" are set for the device when it is manufactured.
The user can modify the device's user name and password to ensure overall system se-
curity. The user name and password can be updated in this tab as shown in Figure "WBM
"Configuration" Page – "Password" Tab". The password must be entered twice in Pass-
word and Confirmed Password textboxes before a change to confirm its correctness.
Please click on the [Submit] button to update the user name and password information
on the switch.
44
Product manual | Version: 1.2.0
Industrial Managed Switch
Description
Select Enable State to enable port mirroring. Deselect Enable State to disable port mir-
roring. Port mirroring must be enabled before the selected Source Port or Destination
Port can be changed
Select a port to copy its ingress (incoming) and egress (outgoing) traffic to the Destina-
tion Port.
Select the port to which the network traffic of the source port should be copied
Figure 30: WBM "Configuration" tab – "Mirror" page
Table 21: WBM "Configuration" tab – "Mirror" page
852-1322
Advertisement
Chapters
Table of Contents
