WAGO 852-1322 Manual page 66

Configuration in the WBM
The Port Security functions can specify the maximum number of MAC addresses per in-
terface. If this number is exceeded, incoming packets with new MAC addresses are
dropped. The allowed MAC addresses are defined automatically after the activation of the
respective port. Once enabled, the switch stores the MAC addresses of the sender in a
table each time a link is established at the port until the permitted number defined by the
user is reached.
When the state of a port on the switch is changed from disabled to enabled, all MAC ad-
dresses captured by that port are deleted.
Note
Configuration of the Port Security
Port security configuration will allow the user to configure MAC limitations to permit the in-
terface. This product supports up to 1,000 MAC address for one port.
66 Product manual | Version: 1.2.0
Industrial Managed Switch
Figure 51: WBM "Security" tab – "Port Security" page
852-1322