Log - WAGO 852-1322 Manual

852-1322 Configuration in the WBM

10.5.3.2 Log

The Log tab page under the System Log as shown in Figure "System Log Page" can dis-
play the log information based on the log level configured in the System Log Setting tab
page (previous subsection). The user has options to either Read all notifications or Read
only the last n records of the log. This can be selected by clicking on the corresponding
radio button.
Figure 41: WBM Page, "Diagnostics" – "System Log" Tab – "Log" Section
To refresh the display or to enable cyclic refresh, click the [Refresh] button. This [Re-
fresh] button is only visible if the Automatic refresh cycle option is not enabled or
stopped. To enable cyclic refresh, click the [Start] button. The [Start] button is only visi-
ble if Automatic refresh cycle option is enabled and has not yet started as shown in Fig-
ure "[[Start] button is visible when Automatic refresh cycle is enabled". To stop cyclic re-
fresh again, click the [Stop]. button. The [Stop] button is only visible if cyclic refresh is
enabled. The user can set the duration of automatic refresh cycle in seconds by entering
the number in the corresponding field. Note that the log records are sorted by date and
time. Table "WBM Page, "Diagnostics" – "System Log" – "Log" Tab" summarizes the de-
scriptions of the parameters in the Log page. Table "Log Event Description" provides de-
scriptions of a log event.
Product manual | Version: 1.2.0 57
Industrial Managed Switch