Table of Contents
Advertisement
852-1322
To set a Modbus Address for the industrial managed switch, choose a number from 1 to
247 and enter it in the Modbus Address field. Click [Submit] button to configure it. To en-
able the Modbus protocol on the industrial managed switch, check the box behind the
Modbus Enable and set a Modbus Port number by choosing a number from 1 to 65535
and enter that number in the Modbus Port field. Click [Submit] button to set the Modbus
TCP. Table "WBM "Diagnostics" Page – "Modbus TCP" Tab" summarizes the descrip-
tions of the Modbus TCP's parameters.
Please refer to Appendix for the Modbus Memory mapping (see chapter
ister
Parameters
Modbus Address
Modbus Enable
Modbus Port
10.5.3 System-Log
10.5.3.1 Setting
The user can enable how the system log (syslog) will be saved and/or delivered to other
system in the System Log Setting tab page as show in Figure" WBM "Diagnostics" Page
– "System Log" – "Setting" Tab". The syslog can be saved to flash memory inside the in-
Product manual | Version: 1.2.0
Industrial Managed Switch
[} 85]).
Factory Default
1
Uncheck
502
Figure 39: WBM "Diagnostics" Page – "Modbus TCP" Tab
Table 27: WBM "Diagnostics" Page – "Modbus TCP" Tab
Description
Enter a number from 1 to 247 to set the Modbus Address of the in-
dustrial managed switch.
Enable the Modbus protocol on the industrial managed switch by
checking the Modbus Enable box.
Enter a number from 1 to 65535 to set the Modbus service port
number for the industrial managed switch.
Configuration in the WBM
8 Modbus-Reg-
55
Advertisement
Chapters
Table of Contents
