Configuration in the WBM
Parameters
Read all notifications Selected
Read only the last n 20
Automatic refresh cy-
cle (sec)
Parameters
Index
Date
58
Product manual | Version: 1.2.0
Industrial Managed Switch
Figure 42: [Start] Button is visible when Automatic refresh cycle is enabled.
Table 29: WBM Page, "Diagnostics" – "System Log" – "Log" Tab
Factory Default
Description
Activate the display of all log messages.
Activate the display of only the last n messages. The user can
also specify the number of messages to be displayed.
Disable, 20
Select the check box to enable cyclic refresh. Enter the cycle time
in seconds in which a cyclic refresh is performed. The label of the
button ("Refresh"/"Start"/"Stop") changes depending on the se-
lected mode.
Description
Indicate the index of a particular log event
Indicate the system date of the occurred log event.
852-1322
Table 30: Log Event Description