FREQUENCIES & CHANNELS
NOTE! If your system is transmitting on the frequency bands 433MHz eller 2.4 GHz, the receiver
will automatically detect and switch to the same channel that the transmitter is using. If your
system is transmitting the 915 MHz frequency band, you have to switch bank in the receiver by
using the PC program Settings manager. Contact your representative for assistance.
Switch channel on the transmitter
1. Make sure that the stop button is pressed.
2. Pull out the stop button.
The top LED lights (green when the battery capacity is good, red when the battery capacity is
poor).
3. Press the right start button. Keep pressed.
4. Press the stop button.
5. Release t he right start button.
The top LED flashes (green when the battery capacity is good, red when the battery capacity is
poor) when in menu mode.
6. Press the right start button. Keep pressed.
7. Press button 4. NOTE! Release button 4 before releasing the right start button.
8. Go to the frequency table and select a channel.
9. Enter a new channel with the buttons according to the table. The LED next to the left start
button lights when a digit has been entered. If the channel that you have selected contains only
one digit, press the left start button directly after entering the first digit.
TG-TX-MNL8, TG-TX-MNR8:
DIGITS
BUTTON TO PRESS
1
1
2
2
3
3
4
4
5
5
6
6
7
the right start button + 1
8
the right start button + 2
9
the right start button + 3
0
the right start button + 4
TG-TX-MXL12, TG-TX-MXR12:
BUTTON TO PRESS
1
2
3
4
5
6
7
8
9
10
- 13 -