Table of Contents
Advertisement
Installing Firmware with Firmware Loader
1.
Open Firmware Loader and establish a connection between the computer and the
device. The Add Device... window opens.
Figure 38.
2.
Select FOX T UWP 302 from the
3.
Select the method of connection from the
4.
Depending on the connection method, additional options appear. Make the appropriate
selections for the current connection method.
5.
Click the
6.
Click the
7.
On the Open window, navigate to the new firmware file, which has an .S19 extension,
and click the
ATTENTION:
any other extension is not a firmware upgrade for this device and could cause the
device to stop functioning.
8.
Click
Add
the Firmware Loader main window.
9.
Click
Begin
10.
Close Firmware Loader when the
Progress
NOTE: See
Add Device... Window
Device Name
button.
Connect
button in the New File Firmware (Optional) section.
Browse
button.
Open
Valid firmware files must have the file extension .S19. A file with
. The Add Device... window closes and the device and firmware are listed in
to start the upload process.
Remaining Time
column shows
, and the
100%
Simple Instruction Set Control
FOX T UWP 302 Wallplate Transmitter • Reference Information
drop-down list.
drop-down list.
Connection Method
field shows
00.00.00
field shows
Status
completed
on page 13 for reset information.
, the
.
40
Advertisement
Table of Contents
