Configuring Ip Address From The Switch Console - HP ProCurve Switch 212M Management And Configuration Manual

Configuring the Switch
IP Configuration

Configuring IP Address from the Switch Console

You can use the console to manually configure an IP address, subnet mask,
and a gateway IP address (if needed). Or, you can use DHCP/Bootp to
configure IP from a DHCP or Bootp server. (To use the DHCP/Bootp option,
you must also configure the DHCP or Bootp server accordingly.)
Do one of the following:
To Access IP Addressing:
1.
The default setting for
Time Protocol Config is
DHCP. Setting it to
Manual, then pressing [v]
or [Tab] causes the Timep
Server Address
parameter to appear.
The default setting for IP
Config is DHCP/Bootp.
Using the Space bar to set
it to Manual, then pressing
[v] or [Tab] causes the IP
Address, Subnet Mask,
and Gateway parameters
to appear.
For descriptions of these
parameters, refer to the
online Help for this screen.
Figure 6-3. Example of the IP Service Configuration Screen
6-8
To use the console, set the IP Config parameter to Manual and then
manually enter the IP address and subnet mask you want for the switch.
If you plan to use DHCP or Bootp, use the console to ensure that the IP
Config parameter is set to DHCP/Bootp, then refer to "DHCP/Bootp
Operation" on page 6-10.
From the Main Menu, select:
2. Switch Management Access Configuration (IP, SNMP, Console)...
1. IP Configuration