Special Case Igmp Configuration - HP ProCurve Switch 212M Management And Configuration Manual

Configuring the Switch
IP Multicast (IGMP) Service Features—Multimedia Traffic Control
Number of IP Multicast Addresses Allowed
The total number of IGMP filters (addresses) allowed in the switch is 255.
Changing the Querier Configuration Setting
The Querier feature, by default, is enabled and in most cases should be left in
this setting. If you need to change the querier setting, you can do so using the
IGMP Configuration MIB.
N o t e
The following commands are all case sensitive.
To disable the querier setting, select Command Prompt from the Diagnostics
Menu and enter this command:
To enable the querier setting, enter this command:
To view the current querier setting, select the Advanced Command prompt
from the Main Menu and enter this command:
N o t e
Whenever IGMP is enabled, the switch generates an Event Log message
indicating whether querier functionality is enabled.

Special Case IGMP Configuration

Normally, all members of a multicast group, both senders and receivers, join
the multicast group through IGMP "join" requests. Certain applications,
though, for example Microsoft
the multicast group before they start sending the multicast data stream.
Because these applications operate in this way, the Switch 212M and 224M
will not be able to recognize the server as part of the multicast group, and will
disable the multicast communication between the server and the client mem-
bers of the multicast group.
If you are using one of these applications, you must first configure the switch
port to which the server is connected to Forward mode.
6-42
setmib hpSwitchIgmpQuerierState.1 -i 2
setmib hpSwitchIgmpQuerierState.1 -i 1
getmib hpSwitchIgmpQuerierState.1
® NetShow ® , do not require the server to join