Components - Fire-Lite Alarms MS-9200 Programming, Installation, Maintenance And Operating Instruction Manual

Components

1.5 Components
JP1
Cabinet
The MS-9200 cabinet is red with an attractive navy blue front overlay. The
backbox provides space for two batteries (up to 7 Amp Hour in old version,
up to 12 Amp Hour in new version). Refer to Figure 2-1, "MS-9200 Cabinet
Dimensions - older version (manufactured through 9/1/98)," on page 21
through Figure 2-4, "MS-9200 Cabinet Mounting - new version," on page
24 [available September 1, 1998], for information on dimensions. Ample
knockouts are provided for system wiring. Also available is an optional
dress panel (DP-9200 for older backbox or DP-1-R for newer backbox) ,
which mounts to the inside of the cabinet (required and included on the ULC
version). The dress panel must be installed to meet FM requirements (refer
to "Dress Panel" on page 16).
Standard
Optional XRM-24
Batteries
The MS-9200 cabinet provides space for two batteries
(up to 7 Amp Hour in old version, up to 12 Amp Hour
in new version). 18 AH batteries require use of the
Fire•Lite BB-17F or similar UL listed battery cabinet.
The newer version MS-9200 main circuit board, which
incorporates jumper JP1 for disabling the FACP
charger, can use the CHG-120F for charging 25 to 120
AH batteries. Batteries must be ordered separately and
require use of the Fire•Lite BB-55F UL listed battery
cabinet.
12
Technical Manuals Online! - http://www.tech-man.com
Transformer Assembly
One 100VA transformer is provided standard with the panel
(3.6 amps maximum). An optional 100 VA transformer
(XRM-24) is available to provide maximum accessory power
(6.6 amp total). Note that transformers are mounted
horizontally (as shown) in the newer version of the cabinet
which will replace the existing cabinet effective September 1,
1998. Transformers mount vertically in the older cabinet.
Battery Cable P/N 75287
Document #15668 Rev.I
firealarmresources.com
Main Circuit Board
The main circuit board contains the system's
CPU, power supply, other primary components
and wiring interface connectors. Optional
modules plug-in and are mounted to the main
circuit board. The circuit board is delivered
premounted in the MS-9200 cabinet. Note that
newer versions of the circuit board have jumper
JP1 which can be cut to disable the FACP
battery charger when using an external battery
charger.
04/20/98 P/N 15668:I