Yamaha TMAX XP500F 2015 Service Manual page 207

EWA13700
WARNING
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
6. Install:
• Rear brake master cylinder assembly "1"
• Rear brake master cylinder holder "2"
Brake master cylinder holder bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
• Install the rear brake master cylinder holder
with the " " mark "a" facing up.
• Align the end of the brake master cylinder hold-
er with the welding line "b" on the handlebar.
• First, tighten the upper bolt, then the lower bolt.
7. Connect:
• Rear brake lock cable
(to rear brake lock lever)
TIP
Lubricate the rear brake lock cable end with
YAMAHA GREASE "F".
8. Install:
• Handlebar switch (left) "1"
• Rear brake lock lever
• Rear brake lock lever holder
TIP
• Align the projection "a" on the left handlebar
switch with the hole "b" in the handlebar.
• Install the rear brake lock cable after rotating
the lever to the position shown in the illustra-
tion.
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
4-76
b
9. Connect:
• Rear brake light switch connector
10.Install:
• Front brake master cylinder assembly "1"
• Front brake master cylinder holder "2"
Brake master cylinder holder bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
• Install the front brake master cylinder holder
with the " " mark "a" facing up.
• Align the end of the brake master cylinder hold-
er with the welding line "b" on the handlebar.
• First, tighten the upper bolt, then the lower bolt.
11.Install:
• Throttle grip "1"
• Throttle cables "2"
TIP
Lubricate the inside of the throttle grip with a thin
coat of lithium-soap-based grease and install it
onto the handlebar.
HANDLEBAR
1
a