2. Check:
• Starter clutch idle gear "1"
• Starter clutch gear "2"
Burrs/chips/roughness/wear → Replace the
defective part(s).
3. Check:
• Starter clutch gear contacting surfaces
Damage/pitting/wear → Replace the starter
clutch gear.
4. Check:
• Starter clutch operation
▼
▼▼▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
a. Install the starter clutch gear "1" onto the
starter clutch "2" and hold the starter clutch.
b. When turning the starter clutch gear counter-
clockwise "A", the starter clutch and the start-
er clutch gear should engage, otherwise the
starter clutch is faulty and must be replaced.
c. When turning the starter clutch gear clock-
wise "B", it should turn freely, otherwise the
starter clutch is faulty and must be replaced.
▲
▲▲▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
GENERATOR AND STARTER CLUTCH
1
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼▼▼
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲▲▲
5-57
EAS31439
CHECKING THE OIL STRAINER
1. Check:
• Oil strainer
Damage → Replace.
Contaminants → Clean with solvent.
EAS31440
ASSEMBLING THE OIL TANK
1. Install:
• Bearing
TIP
Seal "a" is adhered only on one side of the bear-
ing. Note the press-in orientation.
EAS30871
INSTALLING THE STARTER CLUTCH
1. Install:
• Starter clutch
• Starter clutch bolts "1"
Starter clutch bolt
30 Nm (3.0 m·kgf, 22 ft·lbf)
LOCTITE®
TIP
• While holding the generator rotor "2" with the
sheave holder "3", tighten the starter clutch
bolts.
• Do not allow the sheave holder to touch the
projection on the generator rotor.
Sheave holder
90890-01701
Primary clutch holder
YS-01880-A