Yamaha TMAX XP500F 2015 Service Manual page 199

3. Remove:
• Rear brake lock pad (left side) "1"
TIP
Push on the back of the pad using a rod with a
round end.
4. Remove:
• Rear brake lock pad (right side) "2"
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Slide the rear brake lock caliper bracket.
b. Insert a flathead screwdriver in between the
piston adjusting bolt and rear brake lock pad
and then remove the rear brake lock pad.
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
4-68
ECA22110
NOTICE
Avoid scratching the dust seal on the side of
the piston adjusting bolt carefully.
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
5. Measure:
• Rear brake lock pads wear limit "a"
Out of specification → Replace the rear brake
lock pads.
Rear brake lock pad lining thick-
ness
3.0 mm (0.12 in)
Limit
0.8 mm (0.03 in)
6. Remove:
• Cap
• Rear brake lock adjusting nut
• Rear brake lock caliper arm
7. Adjust:
• Piston adjusting bolt
Refer to "ASSEMBLING THE REAR BRAKE
LOCK CALIPER" on page 4-70.
8. Install:
• Rear brake lock caliper arm
• Rear brake lock adjusting nut
• Cap
• Rear brake lock pads
Refer to "ASSEMBLING THE REAR BRAKE
LOCK CALIPER" on page 4-70.
9. Install:
• Rear brake lock caliper
REAR BRAKE
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲