Seco SBC ADLER User Manual page 56

4.4.2 Uncore Configuration submenu
Menu Item Options
20/40/60/80/100/120/14
GOP Brightness Level 0/160/180/200/220/240/
255
GOP Brightness Minimum value
0 .. 100
GOP Brightness PWM Frequency 200 .. 40000
Pull Up 1K
DDI0 DDC Pull Type Pull Up 2K
Pull Up 5K
Pull Up 1K
DDI1 DDC Pull Type Pull Up 2K
Pull Up 5K
Integrated Graphics Device Enabled / Disabled
Primary Display
IGD / PCIe / HG
HG Delay After Power Enable [0..1000]
HG Delay After Hold Reset [0..1000]
RC6 (Render Standby) Enabled / Disabled
GTT Size 2 MB / 4 MB / 8 MB
Aperture Size 256 MB
64M / 96M / 128M /
160M / 192M / 224M /
DVMT Pre-Allocated 256M / 288M / 320M /
352M / 384M / 416M /
448M / 480M / 512M
DVMT Total Gfx Mem 128M / 256M / MAX
144 MHz / 288 MHz /
Cd Clock Frequency 384 MHz / 576 MHz /
624 MHz
ADLER
ADLER User Manual - Rev. First Edition: 1.0 - Last Edition: 1.2 - Author: A.R./S.B. - Reviewed by M.B. Copyright © 2022 SECO S.p.A.
Description
Set Graphics Output Protocol (GOP) Brightness Level
Set GOP Brightness minimum level in %
Set GOP Brightness PWM Frequency
Sets DDI #0 Pull-up values
Sets DDI #1 Pull-up values
Enable the Integrated Graphics Device (IGD) when selected as the Primary Video Adaptor, or always disable it.
Select which of IGD / PCIe /HG graphics device should be the Primary Display
Only available when "Primary Display" is set to HG. Delay in milliseconds after power enable
Only available when "Primary Display" is set to HG. Delay in milliseconds after hold reset
Permits to enable the render standby features, which allows the on-board graphics entering in standby mode to
decrease power consumption
Select the GTT (Graphics Translation Table) Size
Use this item to set the total size of Memory that must be left to the GFX Engine
Select DVMT5.0 Pre-Allocated (Fixed) Graphics Memory size used by the Internal Graphic Device
Select the size of DVMT (Dynamic Video Memory) 5.0 that the Internal Graphics Device will use
Select the highest CD Clock frequency supported by the platform
56