Seco SBC ADLER User Manual page 33

Single board computer with intel atom x series, intel celeron j / n series, intel pentium n series (formerly apollo lake) processors on picoitx form factor

Hide thumbs

Table of Contents

USB_SSTX2+/USB_SSTX2-: USB Super Speed Port #2 transmit differential pair; it is managed by xHCI controller

SATA0_TX+/SATA0_TX-: Serial ATA Channel #0 Transmit differential pair

SATA0_RX+/SATA0_RX-: Serial ATA Channel #0 Receive differential pair

PWR_OFF#: Power Off signal for plugged modules, usually used in battery-

KEYB_W_DISABLE1#: M.2 Key B module disable signal #1, 3.3V_ALW active low output

KEYB_W_DISABLE2#: M.2 Key B module disable signal #2, 3.3V_ALW active low output

UIM_RESET: Reset signal line, sent from M.2 WWAN card to the UIM module.

UIM_DATA: Bidirectional Data line between M.2 WWAN card and UIM module.

UIM_CLK: Clock line, output from M.2 WWAN card to the UIM module.

UIM_PWR: Power line for UIM module.

PLT_RST#: Reset Signal that is sent from the SoC to all devices available on the board (i.e. the GbE controllers and the modules plugged in the CN15 slot). It is a

3.3V active-low signal with 100kΩ pull-down.

CONFIG_[0..3]: Configuration inputs, +3.3V_ALW signals with 10kΩ pull-up. These signals are used to configure properly the Main Host interface according to the

Add-In Card plugged in CN14 Slot. These configuration pins are managed according to PCI Express M.2 Specifications Table 5.5. Only SATA SSDs and WWAN

USB3.1 modules are supported.

ADLER

-up @ 3.3V_ALW

Table of Contents