Seco SBC ADLER User Manual page 50

T5 Delay Enabled / Disabled
P/N Pairs Swapping Enabled / Disabled
Pairs Order Swapping Enabled / Disabled
Bus Swapping Enabled / Disabled
0: +/- 1.56%
1: +/- 3.12%
2: +/- 6.25%
Firmware PLL 3: +/- 12.5%
4: +/- 25%
5: +/- 50%
6: +/- 100%
4.3.16 SMBIOS Information
Display only screen, shows information about the module and the Carrier board.
4.3.17 Embedded Controller submenu
Menu Item Options
Always ON
Power Fail Resume Type Always Off
Last State
No C-MOS battery handling Disabled / Enabled
None
1
OUT 80 serial redirection port
2
1+2
Hardware Monitor
Reset Causes Handling
Super IO Configuration See Submenu
Internal FAN Settings See Submenu
ADLER
ADLER User Manual - Rev. First Edition: 1.0 - Last Edition: 1.2 - Author: A.R./S.B. - Reviewed by M.B. Copyright © 2022 SECO S.p.A.
When Enabled, T5 is delayed by 20ms ± 50%
Enable or disable LVDS Differential pairs swapping (Positive  Negative)
Enable or disable channel differential pairs order swapping (A  D, B  CLK, C  C)
Enable or disable Bus swapping (Odd  Even)
Set Firmware PLL range
Description
Specifies what must happen when power is re-applied after a power failure (G3 state).
Always ON: the System will boot directly as soon as the power is applied.
Always OFF: the system remains in power off State until power button is pressed
This option is enabled when "Power Fail resume Type" is set to Always OFF or Last State.
In system with no C-MOS battery, the chipset always powers on after a power failure: Always OFF
Resume Type or Last State when Last State was OFF will therefore require an immediate shutdown
Selects which Embedded Controller's UART(s) will receive OUT 80 (Post Codes)
By selecting this item, an information screen with System parameters will appear
By selecting this item, an information screen with the handling of latest resets causes will appear
Sets the parameters for Serial Ports
Sets the parameters for internal (i.e. on module) FAN
50