Seco SBC ADLER User Manual page 58

Set LPSS I2C #4 Speed
4.4.3.3
PCI Express Configuration submenu
Menu Item
Compliance Mode
PCIE Root Port 3 - M.2 TYPE 2230 (CN15)
PCIE Root Port 4 Internal LAN 0 (CN20)
PCIE Root Port 5 Internal LAN 1 (CN21)
4.4.3.3.1 PCIE Root Port #x submenus
Menu Item
PCIE Root Port 3 - M.2 TYPE 2230
PCIE Root Port 4 Internal LAN 0
PCIE Root Port 5 Internal LAN 1
ASPM
PCIe Speed
PCIe Selectable De-Emphasis
4.4.3.4
SATA Drives Configuration submenu
Menu Item
SATA Controller
ADLER
ADLER User Manual - Rev. First Edition: 1.0 - Last Edition: 1.2 - Author: A.R./S.B. - Reviewed by M.B. Copyright © 2022 SECO S.p.A.
ACPI Mode
Standard Mode
Fast Mode Only available when LPSS I2C #4 is not disabled. Select LPSS I2C #4 Speed
Fast Plus Mode
Options Description
Enabled / Disabled Compliance Mode Enable/Disable
See submenus Sets the parameters for each single PCI-e Root Port
Options Description
Controls the PCI Express Root Port.
Auto
Auto: disable unused root port automatically for the most optimised power saving.
Enabled
Enable: Always enable the PCIe root port.
Disabled
Disable: Always disable the PCIe root port
Disable / L0s PCI Express Active State Power Management Settings
Auto
Gen1 Configure PCIe Speed
Gen2
When the Link is operating at 5.0 GT/s speed, this bit selects the level of de-emphasis for an Upstream
component.
Enabled / Disabled
1b -3.5dB
0b -6dB
Options Description
Enable / Disable Chipset SATA controller, which supports the 2 black internal SATA ports (up to 3GB/s
Enabled / Disabled
supported per port).
(all the following items will disappear)
58