M&C PSS Series Instruction Manual page 43

Table of Parameter Codes
No. Description:
1 Software version
5 Brightness setting of
display
10 LA on/off switching
11 Sensitivity LA
12 HIGH dT
13 LOW dT
14 Hysteresis
(temperature alarm)
15 mA range selection
70 Operating time in
days
84 Fan speed
210 Calibration LA dry
211 Calibration LA wet
212 Calibration LA open
/ cable break
213 Display LA dry
214 Display LA wet
215 Display LA open
310 mA output
Calibration
311 mA output HIGH
Calibration
www.mc-techgroup.com
Default: Range:
5 0 - 9
0 0,1,2
2 1-7
3 2 - 8 [°C]
3 2 - 8 [°C]
2 1,2 [°C]
4-20 0-20 / 4-
20 [mA]
1 0-5
LOW 1 mA
20 mA
SS5C, SS5C/2, SS5C/3 | 1.00.00
Note:
Brightest display setting is 9
0=off; 1= without cable break detection; 2= with cable
break detection
The higher the value is, the sooner the alarm is triggered.
Differential temperature between set point and upper
temperature alarm limit
Differential temperature between setpoint and lower
temperature alarm limit
As soon as a temperature alarm limit of "2" is selected, the
hysteresis is automatically reduced to 1
Corresponds to the temperature range: -10 °C to +50 °C
(4 – 20 mA: at 5 °C = 8 mA)
This value will not be deleted even after restarting
Value has no influence on the output power
Connect the sensor and confirm with the
Hold the sensor in water and confirm with the
Disconnect the sensor and confirm with the
cable break detection triggers in the middle between
this value and that of dry.
Check here the current value
Check here the current value
Check here the current value
Connect the multimeter and press or hold
until the display matches 1mA.
Connect the multimeter and press and hold
keys until the display matches 20 mA.
-key.
-key.
-key. The
or -keys
or -
43