Fan Speed Setting; Brightness Setting Of Display - M&C PSS Series Instruction Manual

12.2

FAN SPEED SETTING

The ECPX000C is equipped with a large cooling fin block which is forced-ventilated by a fan. The minimum speed
of the fan can be changed without affecting the final performance of the cooler.
To change the fan speed setting:
1. Enter the PIN (see chapter "11.2 PIN Entry").
2. Tap and hold the
3. The display shows the code entry.
4. The code for setting the fan speed is "084". The setting range is between 0 and 5. At level 0 the fan rotates
slower and is quieter. At higher values, the fan rotates faster and the air flow rate is increased.
Level 2 is set by default This fan speed is necessary to reduce the temperature increase inside the case.
12.3

BRIGHTNESS SETTING OF DISPLAY

It may be necessary to change the brightness of the display due to different lighting conditions at the locations
where the cooler is used. The brightness of the display can be adjusted on the control panel of the ECPX000C.
To change the brightness setting:
1. Enter the PIN (see chapter "11.2 PIN Entry").
2. Tap and hold the
3. The display shows the code entry.
You can also enter the code from the main menu. To do this, keep the
displayed. The PIN must be active in this case.
After changing the brightness or canceling, the display shows the cooler temperature again.
22
-key for a short moment.
-key for a short moment.
Enter the code "005" and confirm the code with the
Now the default brightness value appears. The factory setting is "5".
This value is blinking and can be set between "0" and "9" with the
- keys. The brightness of the digits changes immediately. The lower the
value, the darker the display.
Select the desired brightness value and confirm the selection with the
key or cancel the procedure with the key. Use the
of codes without making any changes.
SS5C, SS5C/2, SS5C/3 | 1.00.00
--key pressed until the code entry is
--key.
-key to leave the range
www.mc-techgroup.com
and
-