Pin Entry - M&C PSS Series Instruction Manual

Tap on the
Note
The cooling temperature is shown in the display as follows:
Note
11.2

PIN ENTRY

To enter the range of set point input or parameter setting, a PIN must be entered. The PIN "1234" is factory-set
and cannot be changed.
To enter the PIN, proceed as follows:
18
-key, to go back to the cooling temperature.
The cooler temperature is shown on the display.
The ambient temperature is indicated by a "°" sign on the left side of the
displayed temperature.
The set point for absolute value control is indicated by an "A" and the set
point for differential control by a small "d" before the temperature value.
The absolute value control temperature can be set between 2 to 15 °C [35.6
to 59 °F]. The differential value control temperature can be set between dT =
2 to 15 °C [dT = 3.6 to 27 °F].
The display of the current signal value is indicated by a capital "P" on the
right-hand side. The signal value is a measure for the percentage workload.
The signal value can assume values from 0 to 99.
You will find the complete menu structure in the appendix of the ECPX000C
instruction manual.
Press and hold the
The "0" on the left side is blinking. Use the
digit of the PIN.
Use the and
the PIN digit can be entered.
The PIN "1234" looks like this on the display.
Confirm the PIN with the
SS5C, SS5C/2, SS5C/3 | 1.00.00
-key until "0000" appears in the display.
- keys to switch to the other digits. If a digit is blinking,
-key.
and - keys to enter the first
www.mc-techgroup.com