Set Point Entry; Figure 8 Reaching The Set Point Entry From The Ecp1000C/Ecp3000C Main Menu - M&C PSS Series Instruction Manual

After confirmation, immediately the display for the set point entry is shown. Press and hold the
access the parameter setting area.
The PIN is valid for 15 minutes. If you exceed this time, the display field reappears with "0000" when you press and
hold the -key. The PIN must be entered there again.
11.3

SET POINT ENTRY

If you tap the -key briefly after entering the PIN (see chapter "11.2 PIN Entry"), the set point for the cooler
temperature appears. This set point can belong to the operating mode "absolute control" ("A") or "differential
control" ("d").
The two digits start blinking. The absolute value control temperature can be set from 2 to 15 °C [35.6 to 59 °F]
using the and -keys. The differential value control temperature can be set from dT = 2 to 15 °C [dT = 3.6 to
27 °F] using the and
Note
As long as the PIN is active (see chapter "11.2 PIN Entry"), the set point entry can also be accessed from the main
menu. To change a set point, press the
The display then changes to set point input. The two digits start blinking. Values can be set here.
The following figure shows, using the example of an ECP1000C/ECP3000C, how to access the set point input from
the main menu.
2 s
Figure 8 Reaching the set point entry from the ECP1000C/ECP3000C main menu
www.mc-techgroup.com
-keys. The factory setting is absolute value control temperature of 5 °C [41 °C].
Use the and
point settings.
If the letter on the left side is blinking, you can use the
switch between absolute and differential value control of the set point
temperature.
Tap the -key, then the entries are discarded, and you return to the cooler
temperature.
- key for 2 seconds during the current temperature or set point display.
2 s
SS5C, SS5C/2, SS5C/3 | 1.00.00
-keys to switch between the operating mode and set
-key longer to
and -keys to
19