Set Point Entry; Figure 10 Reaching The Set Point Entry From The Ecp1000C/Ecp3000C Main Menu - M&C PSS Series Instruction Manual

After confirmation, immediately the display for the set point entry is shown. Press and hold the
longer to access the parameter setting area.
The PIN is valid for 15 minutes. If you exceed this time, the display field reappears with "0000" when
you press and hold the
12.3

Set Point Entry

If you tap the -key briefly after entering the PIN (see chapter "12.2 PIN Entry"), the set point for the
cooler temperature appears. This set point can belong to the operating mode "absolute control" ("A")
or "differential control" ("d").
The two digits start blinking. The absolute value control temperature can be set from 2 to 15 °C [35.6
to 59 °F] using the
to 15 °C [dT = 3.6 to 27 °F] using the
temperature of 5 °C [41 °C].
N O T E
As long as the PIN is active (see chapter "12.2 PIN Entry"), the set point entry can also be accessed
from the main menu. To change a set point, press the
temperature or set point display. The display then changes to set point input. The two digits start
blinking. Values can be set here.
The following figure shows, using the example of an ECP1000C/ECP3000C, how to access the set
point input from the main menu.
2 s
Figure 10 Reaching the set point entry from the ECP1000C/ECP3000C main menu
www.mc-techgroup.com
-key. The PIN must be entered there again.
and -keys. The differential value control temperature can be set from dT = 2
and
Use the and
set point settings.
If the letter on the left side is blinking, you can use the
-keys to switch between absolute and differential value control of
the set point temperature.
Tap the -key, then the entries are discarded and you return to the
cooler temperature.
2 s
-keys. The factory setting is absolute value control
-keys to switch between the operating mode and
- key for 2 seconds during the current
PSS-5C | 1.02.02
-key
and
23