Pin Entry - M&C PSS Series Instruction Manual

Tap on the
N O T E
The cooling temperature is shown in the display as follows:
N O T E
12.2

PIN Entry

To enter the range of set point input or parameter setting, a PIN must be entered. The PIN "1234" is
factory-set and cannot be changed.
To enter the PIN, proceed as follows:
22
-key, to go back to the cooling temperature.
The cooler temperature is shown on the display.
The ambient temperature is indicated by a "°" sign on the left side of
the displayed temperature.
The set point for absolute value control is indicated by an "A" and the
set point for differential control by a small "d" before the temperature
value.
The absolute value control temperature can be set between 2 to
15 °C [35.6 to 59 °F]. The differential value control temperature can
be set between dT = 2 to 15 °C [dT = 3.6 to 27 °F].
The display of the current signal value is indicated by a capital "P" on
the right-hand side. The signal value is a measure for the percentage
workload. The signal value can assume values from 0 to 99.
You will find the complete menu structure in the appendix of the
ECPX000C instruction manual.
Press and hold the
The "0" on the left side is blinking. Use the
the first digit of the PIN.
Use the and
blinking, the PIN digit can be entered.
The PIN "1234" looks like this on the display.
Confirm the PIN with the
PSS-5C | 1.02.02
-key until "0000" appears in the display.
- keys to switch to the other digits. If a digit is
-key.
www.mc-techgroup.com
and - keys to enter