Data Boxes; Showing, Hiding Data Boxes With Soft Key; Rearranging Data Boxes; Temporarily Erasing A Data Box - Furuno NAVNET 1734C Operator's Manual

1. OPERATIONAL OVERVIEW
1.8

Data Boxes

Data boxes, providing navigation data, may be shown on any full-screen display. Up to six
data boxes (two in case of large characters) may be shown, and the default data boxes are
position (in latitude and longitude), course over ground, speed over ground and trip log. The
user may choose which data to display, where to locate it, and show or hide it as desired. In
addition, data boxes may be set independently for each display mode (plotter, radar,
sounder). For how to select data for the data boxes, see the paragraph "7.5 Data Boxes
Setup."

1.8.1 Showing, hiding data boxes with soft key

Plotter: D. BOX ON/OFF
Radar: ZOOM & D. BOX
box also shown/hidden)
Sounder: AUTO/D. BOX D. BOX ON/OFF

1.8.2 Rearranging data boxes

You may select the location for data boxes as follows:
1. Using the Cursor pad, place the cursor inside the data box you wish to move. As the
cursor enters the box it changes to a "hand". Push the ENTER knob, and the hand
changes to a fist, meaning the box is correctly selected.
2. Use the Cursor pad to move the data box to the location desired, then push the ENTER
knob.

1.8.3 Temporarily erasing a data box

If a data box is obscuring a desired object, you may temporarily erase the box. Use the
Cursor pad to place the cursor inside the data box you wish to erase, then press the
CLEAR key. To redisplay the box, press the D. BOX soft key twice to display it.
1-14
.250/ 319.9
.125nm
M
SP
H-UP
TRIP LOG
177
nm
POSITION
COG
47
58.535'N
323.6
122 M
36.496'W
Data boxes
Data boxes
D. BOX ON/OFF (EBL/VRM data box, cursor data
MARK
ENTRY
MODE
NTH UP
NAV
POS
D.BOX
ON
/OFF
SOG
20.0
kt
350.4 M
0.000 nm