Activating Targets; Displaying Target Data - Furuno NAVNET 1734C Operator's Manual

5. AIS OPERATION
5.4

Activating Targets

Use the trackball to place the cursor on the sleeping AIS target (indicates only the presence
of a vessel equipped with AIS in a certain location) you wish to activate; that is, know more
about a vessel's motion.
*1: Vector shows STW (speed thru water) and CSE (course) when water tracking mode is
selected at the radar.
*2: If there is no heading data, the line points in direction of COG.
5.5

Displaying Target Data

Plotter display: Place the cursor on an AIS target symbol.
Radar display: Place the cursor on an AIS target symbol. Press the TARGET soft key then
the TARGET INFO soft key.
Activated target selected for data display (radar display only)
Course over Ground*, Speed over Ground#
5-4
SOG and
COG vector
*1
Heading
line*2
Activated target
MMSI No.
Ship's Name
CPA and TCPA
Bearing, Range
Beam, Length
* = CSE (course) when water tracking mode is selected at radar.
# = STW (speed thru water) when water tracking mode is selected at radar.
AIS target data display
Turning
direction
MMSI 123456789
NAME QUEEN ELIZABETH
°
COG 359 SOG 23.2kt
CPA 2nm TCPA 12:35
BRG 359.4 RNG 10.8nm
BEAM 32m LENGTH 294m