Clearing Memories - Furuno NAVNET 1734C Operator's Manual

8. MAINTENANCE, TROUBLESHOOTING
8.8

Clearing Memories

Your equipment has a memory for each of the plotter, radar and sounder sections. These
memories can be cleared to restart operation with default settings.
The following data are not cleared:
Radar: Heading adjustment, timing adjustment, MBS level, tuning point, tuning indication
(short, medium, long), video level, dead sector, antenna height, STC curve, antenna type,
on time, tx time, Sounder: White marker, hue, signal level, TLL output, depth calibration,
range.
1. Press the MENU key to open the menu.
2. Press the SYSTEM CONFIGURATION soft key.
3. Press the SYSTEM SETUP soft key.
4. Press the TEST & CLEAR soft key.
5. Press the MEMORY CLEAR soft key.
6. Use the Trackball to choose the memory to clear.
7. Press the EDIT soft key.
8. Use the Trackball to select YES, then press the ENTER soft key. One of the following
displays appears depending on the selection made at step 6.
ALL SETTNGS EXCEPT
SNDR ARE RESET TO
DEFAULT. ARE YOU SURE?
YES ... PUSH ENTER KNOB
NO ... PUSH CLEAR KEY
Display Unit Clear
9. Push the ENTER knob to clear the memory selected.
10. Press the MENU key to close the menu.
11. Turn the power off and on again.
8-12
DISPLAY UNIT
NO
GPS SENSOR
NO
NETWORK SOUNDER
NO
Memory clear menu
BEGIN COLD START
TO CLEAR GPS
MEMORY. ARE YOU SURE?
YES ... PUSH ENTER KNOB
NO ... PUSH CLEAR KEY
GPS Receiver Clear
Windows for clearing memory
MEMORY
CLEAR
EDIT
RETURN
SOUNDER WILL BE
SET TO DEFAULT.
ARE YOU SURE?
YES ... PUSH ENTER KNOB
NO ... PUSH CLEAR KEY
Network Sounder Clear