Clearing Memories - Furuno NAVpilot-500 Operator's Manual

6. MAINTENANCE & TROUBLESHOOTING
SYSTEM DATA
You can confirm the current equipment and drive system status.
1. Press the [MENU] key to show the mode menu.
2. Rotate the [ENTER] knob to select "SYSTEM DATA".
3. Press the [ENTER] knob to show the system data screen.
6.4

Clearing Memories

Memories can be cleared to restore to default settings.
1. Press the [MENU] key to show the menu.
2. Rotate the [ENTER] knob to select "SYSTEM SETUP".
3. Press the [ENTER] knob to show the System setup menu.
4. Rotate the [ENTER] knob to select MEMORY CLEAR at the bottom of the
second page.
5. Press the [ENTER] knob to show the memory clear options window.
6. Rotate the [ENTER] knob to select ALL CLEAR or DISPLAY CLEAR as
appropriate.
ALL CLEAR: Restores all default settings.
DISPLAY CLEAR: Restores settings other than the installation settings, ship's
moving feature and compensation for the sensor connected.
Note: If you select ALL CLEAR, the all memories and settings stored in the
7. Press the [ENTER] knob. You are asked if you are sure to clear memory
selected
8. Press the [ENTER] knob to clear, or press any key to escape.
When the [ENTER] knob is pressed, the equipment restarts automatically.
6-6
INPUT VOLTAGE:
CONTROLLER ID:
DRIVE TYPE:
BYPASS/CLUTCH:
CONTROLLER TEMP:
FET TEMP.:
MOTOR DRIVE CUR.:
BYPASS/CLUTCH CUR.:
Memory clear options window
equipment are erased.
SYSTEM DATA
24.4 V
1
SOLENOID
NON
43.4 F
24.6 F
0.0 A
0.0 A
System data screen
ALL CLEAR
DISPLAY CLEAR