Installing Components; Installing A New Power Supply Unit And Ac Inlet Accessory In An Empty Slot - Aruba 6400 Series Installation And Getting Started Manual

Installing Components

Protect the switch and components from damage caused by ESD (electrostatic discharge). For more
information, see Grounding the Chassis
Always wear an ESD wrist strap when handling the switch or its components. Ensure the strap is reliably
grounded to an unpainted metal grounding point when installing or removing switch components.
Hold management modules and line modules by their edges. Do not touch any electronic components
n
or printed circuitry.
Store uninstalled modules in antistatic bags.
n
Handle your Aruba 6400 Switch components with care. Rough or careless handling can damage the
n
components and result in unplanned down time.
Figure 25 Unpainted surfaces on the switch make good grounding points for the ESD strap
1 ESD wrist strap connection point on front panel. In this case, the connection point is the metal tab that
is exposed when the bezel is removed.
2 ESD wrist strap connection point (grounding lug) on rear panel
Installing a New Power Supply Unit and AC Inlet Accessory
in an Empty Slot
Mount the 6400 chassis in a rack or other location as described in
Aruba 6400 Switch | Getting Started Guide
Installing Components
Mounting the Switch.
Chapter 7
64