Aruba 6400 Series Installation And Getting Started Manual page 48

For detailed mounting information, see
page 53.
Switch packaging is not designed to accommodate transceivers installed in line modules. If you plan to re-
ship the switch in its original packaging, remove any transceivers installed in line modules before preparing
the switch for shipment.
Two-Post Rack Mounting
Preparing the Chassis for a Two-Post Rack Mounting
Before you begin, ensure that the following prerequisites are met:
A two-post equipment rack assembled and properly secured.
n
Verification that the rack is certified to support the weight of all equipment you plan to mount on it. (For
n
Aruba 6400 switch and component weight information, see
The front rack mounting brackets, related screws, and screwdrivers.
n
Two-post rack mount option selected.
n
The Aruba 6410 switch uses two front rack mounting brackets on each side.
If you plan to install the (included) cable manager on the switch, you must install the rack mounting
brackets in the front rack mount position, flanges flush with the front of the switch.
Figure 17 Two-post rack mount options
1
Mounting position "1".
NOTE: If you plan to install the cable manager on the switch, you must use mounting position "1" to
mount the switch in the rack.
2 Mounting position "2".
Aruba 6400 Switch | Getting Started Guide
Preparing the Chassis for an Optional Four-Post Rack Mount on
Aruba 6400 Product Weights on page 89.)
48