Aruba 6400 Series Installation And Getting Started Manual page 56

switch).
1
2
3
4
5
6
7
a. Use an unattached rack mounting bracket to help determine the proper rack post positions for
the cage nuts.
b. Insert a cage nut into the top hole in both of the 1U sections immediately above the mounted
rail on both of the front posts of the rack. (See callouts 6 and 5.)
c. Skip the third 1U above the rails. (See callout 4.)
d. Insert a cage nut into the bottom hole in both of the next two 1U sections. (See callouts 3 and 2.)
Installing Rail Spacers and Front Rack Mounting Brackets for the Four-Post
Rack Mounting
When mounting the switch in a four-post rack, the front rack mounting brackets must be attached in
mounting position 1, with the flange positioned flush with the front panel of the switch.
1. Using the screws provided with the R0X37A four-post rack mounting kit, Attach a rail spacer to the
bottom edge of each side of the chassis, as shown.
Aruba 6400 Switch | Getting Started Guide
Unattached rack mounting bracket used as a guide for cage nut placement. (See
step 3a, below.)
Cage nut at bottom of seventh 1U.
Cage nut at bottom of sixth 1U.
No cage nuts in fifth 1U.
Cage nut at top of fourth 1U.
Cage nut at top of third 1U.
Installed rail; uses 2U.
56