Aruba 6400 Series Installation And Getting Started Manual page 50

Figure 20 Two-post rack mount using the middle (number 2) mounting position
Manually Mounting the Chassis in a Two-Post Rack
This procedure is for two or more persons manually mounting an Aruba 6405 five-slot chassis weighing less
than 45 kg (100 lbs), or four persons manually mounting an Aruba 6410 ten-slot chassis weighing less than
90 kg (200 lbs) in a two-post rack. For weights exceeding these limits, reduce the weight of the chassis or use
a mechanical lift. See
information on using a mechanical lift. See also
Prerequisites
The front rack mounting brackets included with the switch are installed on the chassis.
n
The screwdriver and rack mounting screws are available in easy reach.
n
Procedure
1. On both rack posts, partially install a rack mounting screw at the level you want the bottom of the
chassis to rest. Leave a gap between the screw heads and the surface of the posts sufficient to allow
the mounting bracket to rest on each post.
Aruba 6400 Switch | Getting Started Guide
Using a Mechanical Lift to Mount the Chassis in a Two-Post Rack on page 51
Aruba 6400 Product Weights on page
for more
89.
50