Aruba 6400 Series Installation And Getting Started Manual page 54

The four-post slide rails support only square hole and round hole rack configurations. They do not
support threaded hole rack configurations.
The equipment rack shown in this publication is for illustration purposes only, and may not match the
equipment rack you are using.
1 Adjustable slide rail (left side)
2 Adjustable slide rail (right side)
3 Rear post rack brackets
4 Chassis rail spacers
5 Rear adapter plates
6 Cage nuts
7 Flathead and 10-32 screws
Installing Rack Rails
1. Select the desired rail position in the rack and install the adjustable rails by aligning the pins and
engaging the clips front and back. The rails require 2U of rack height. The rail pins fit in the bottom
and top rack holes in the lower 1U, and in the top rack hole in the upper 1U.
Aruba 6400 Switch | Getting Started Guide
Attaches to left side rack front and rear posts
Attaches to right side rack front and rear posts
Attach to rear adapter plates and to rear rack posts
Attach to bottom (left-side and right-side) of chassis and front rack
posts
Attach to chassis (left-side and right-side) in rear mounting
position 3 and to rear post rack brackets
54