Aruba 6400 Series Installation And Getting Started Manual page 52

If you are not using a mechanical lift, then skip this section and see
Post Rack on page
Before you begin, ensure that the front rack mounting brackets included with the switch are installed on the
chassis.
A fully populated Aruba 6405 chassis weighs up to 61 kg (133 lbs). A fully populated Aruba 6410 chassis
weighs up to 100 kg (219 lbs) Ensure that the combined weight of the chassis with all components
installed does not exceed the maximum load capacity of your mechanical lift. For component weights,
see Aruba 6400 Product Weights on page 89
Use the following procedure to use a mechanical lift to mount the chassis in a two-post rack.
1. On both rack posts, partially install a rack mounting screw at the level you want the bottom of the
chassis to rest. Leave a gap between the screw heads and the surface of the posts sufficient to allow
the mounting bracket to rest on each post.
2. Raise the switch and position it between the rack posts so that the lower ends of the rack mounting
brackets line up to be lowered on to the screws you installed in step 1.
Aruba 6400 Switch | Getting Started Guide
50.
Manually Mounting the Chassis in a Two-
52