Replacing Components; Replacing The Fan - Aruba 6300F Series Installation And Getting Started Manual

Replacing components

This chapter describes how to remove and install the following components in the Aruba 6300M Switch
Series:
Power supply
n
Fan tray
n
There are no user-replaceable parts on the Aruba 6300F Switch Series.
The 6300M switches and their components are sensitive to static discharge. Use an antistatic wrist strap and
observe all static precautions when replacing components.
If a power supply must be removed, and then reinstalled, wait at least 5 seconds before re-installation. Otherwise,
damage to the switch may occur. The power supply needs this time to bleed off any retained power.

Replacing the fan

If a fan has failed, the fan LED will flash simultaneously with the switch Fault LED. Replace the failed
component as soon as possible.
JL762A (Aruba 6300M 48G Pwr2Prt 2F 1PS Bdl) has power-to-port (back-to-front) airflow and requires two JL761A
(Aruba 6300M Power-to-Port Fan Tray). Other 6300M fan trays are not supported in the JL762A switch. All other
6300 switches have port-to-power (front-to-back) airflow; JL761A fan trays are not supported in any other 6300M
switch other than the JL762A.
To Remove an Existing Fan:
Aruba 6300F/M Switch Series Installation and Getting Started Guide | (xxxx Switch Series)
Chapter 4
Replacing components
37