Table of Contents
Advertisement
6. Launch the board user interface application.
On first use of the board user interface, go to the FMC → Set VADJ → Boot-up tab and click USE
FMC EEPROM Voltage. The board user interface buttons gray out during command execution
and return to their original appearance when ready to accept a new command.
See the ZCU670 System Controller GUI Tutorial (XTP698) and the ZCU670 Software Install and
Board Setup Tutorial (XTP699) for more information on installing and using the system controller
board user interface utility.
Switches
[Figure
2, callouts 23 and 24]
The ZCU670 board includes the following power, configuration, and reset switches:
• SW15 power on/off slide switch (callout 24)
• SW3 (PS_PROG_B), active-Low pushbutton (callout 23)
• SW4 (POR_B), active-Low pushbutton (callout 23)
• SW5 (SRST_B), active-Low pushbutton (callout 23)
• SW2 U1 RFSoC PS bank 503 4-pole mode DIP switch (callout 23)
Power On/Off Slide Switch
[Figure
2, callout 24]
The ZCU670 board power switch is SW15. Sliding the switch actuator from the off to on position
applies 12V power from J50, a 6-pin mini-fit connector. Green LED (DS19) illuminates when the
ZCU670 board power is on. See
UG1532 (v1.0) March 30, 2022
ZCU670 Board User Guide
Board Power System
for details on the onboard power system.
Chapter 3: Board Component Descriptions
Send Feedback
www.xilinx.com
57
Advertisement
Table of Contents
