Connections - Extron electronics Dual Link DVI Transmitter and Receiver DVI DL 201 Rx User Manual

TIA/EIA
Pin # T 586 A
Wire color
1 White-green
2 Green
3 White-orange
4 Blue
5 White-blue
6 Orange
7 White-brown
8 Brown
6. Feed the wires into the RJ-45
connector (see the figure at right)
and crimp the cable in the normal
manner (see the figure below),
folding the tangs of the connector
over the shielded tape.

Connections

Use RJ-45 connectors to link the output from the transmitter
to the appropriate input on the receiver. Three CAT 5/5e/6/7
twisted pair (TP) cables connect the transmitter with the
receiver.
N
Connect the output from the transmitter to the input of the
receiver that has the same number:
• Transmitter port 1 connects to receiver port 1.
• Transmitter port 2 connects to receiver port 2.
• Transmitter port 3 connects to receiver port 3.
TIA/EIA
T 586 B
Wire color
White-orange
Orange
White-green
Blue
White-blue
Green
White-brown
Brown
Crimped Connector
The transmitter and receiver pair works with unshielded
twisted pair (UTP) or shielded twisted pair (STP) cables.
To ensure FCC Class A and CE compliance, and for
optimum performance, STP cables are recommended.
DVI DL 201 Tx/Rx • Installation
Cable 1 Cable 2
Data 0+ CEC
Data 0+ HPD
IDCK+ RS-232 Tx/IR+
Data 1+ DDC Clock
Data 1+ +12 V
IDCK- RS-232 Rx
Data 2+ DDC Data
Data 2+ Ground
Cable 3
Data 3+
Data 3+
N/C
Data 4+
Data 4+
N/C
Data 5+
RJ-45
Data 5+
Connector
Side Pins:
1 2 3 4 5 6 7 8
Insert
Twisted
Pair Wires
2-15