Dvi Dl 201 Tx Rear Panel Features - Extron electronics Dual Link DVI Transmitter and Receiver DVI DL 201 Rx User Manual

DVI DL 201 Tx rear panel features

The illustration below shows the rear panel features of the
DVI DL 201 Tx.
DVI DL 201 Tx
SN XXXXXXXX E XXXXX
DVI DL TX
POWER
12V
DVI-D INPUT
0.4A MAX
2 3
DVI DL 201 Tx rear panel features
b
Power input — The 12 VDC power supply (provided) connects
to this two-pole, 3.5 mm captive screw connector.
c
DVI-D input — One female DVI-I connector accepts a dual-link
DVI-D input from the source device.
d
Local monitor output — One female DVI-I connector provides a
dual-link DVI-D output to the local monitor.
e
EDID Minder Store switch and LED — When depressed, the
transmitter reads and stores the EDID information from the local
monitor. The LED gives the status of this process.
f
DDC route switches — Three DIP switches allow the unit to be
configured to use the EDID Minder or route the DDC directly to
the display.
g
Control signal pass-through — A three-pole, 3.5 mm captive
screw connector inputs pass-through RS-232 (two-way) or IR
signals (one-way).
h
Twisted pair outputs — Three RJ-45 jacks are used for
transmitting DVI video, remote power, and communications/
control signals.
N
00/00
LOCAL OUTPUT
4
The DVI DL 201 transmits high frequency signals via
these TP outputs. Connections between the transmitter
and receiver must be point to point. It is recommended
that there should be no couplers, adapter, or patch panels
between the transmitter and receiver units.
DVI DL 201 Tx/Rx • Installation
CONTROL
EDID
PASS THRU
ON
ON Tx Rx
STORE
1 2 3
OFF
5 6 7
DO NOT CONNECT
OUTPUTS TO LAN
OUTPUTS
1 2
3
8
2-9