Through-Desk Mounting - Extron electronics Dual Link DVI Transmitter and Receiver DVI DL 201 Rx User Manual

Through-desk mounting

The DVI DL 201 Tx should not be mounted through a desk.
To mount the DVI DL 201 Rx through a desk or podium, use
the optional Extron MBD 129 through-desk mounting kit
(PN 70-077-02), and follow these instructions:
1. Remove rubber feet if these have been installed on the
bottom of the unit.
2. Attach the brackets to the receiver, using the four 4-40
screws provided; leave the screws slightly loose.
Through-desk mounting the DVI DL 201 Rx
3. Hold the unit in position under the mounting surface.
Mark the location of the four screw holes and the
mounting hole to be cut in the table.
4. Cut away the table material. Test the fit by inserting the
front of the device through the hole. If necessary, use a
rasp or coarse file to enlarge the hole.
5. Hold the receiver, with the brackets attached, in position
and mark the location of the holes in the brackets. Drill
four pilot holes, each 3/32" (2 mm) in diameter by 1/4"
deep (6.3 mm) deep.
6. Attach the brackets to the mounting surface, using the four
#8 wood screws provided with the kit.
7. Slide the device in or out until the front panel is flush with
the table surface. Tighten the screws installed in step 2.
8. If the screws are inaccessible to a screwdriver, mark the
location of the unit relative to the brackets, remove the unit
and brackets, tighten the screws holding the brackets and
replace the unit as described in step 6.
DVI DL 201 Tx/Rx • Installation 2-5