Extron electronics Dual Link DVI Transmitter and Receiver DVI DL 201 Rx User Manual page 43

Video output — receiver
Number/signal type..................... 1 dual link DVI-D
Dual link DVI is backwards compatible with all single link
N
DVI/HDMI signals.
Connectors ..................................... 1 DVI-I female
Control/remote — external device (pass-through)
Serial control port input
Transmitter ......................... RS-232 via (1) 3.5 mm, 3 pole captive screw
Receiver .............................. 1 set of proprietary signals on a female
Serial control port output
Transmitter ......................... 1 set of proprietary signals on a female
Receiver .............................. RS-232 via (1) 3.5 mm, 3 pole captive screw
Protocol is mirrored between the transmitter and the receiver.
N
Serial control pin configuratins... Captive screw connectors: 1-TX, 2=RX,
General
Recommended cable type ............ CAT 5/5e/6/7 (shielded or unsheilded)
External power supply ................. 100 VAC to 240 VAC, 50/60 Hz, 6 W max.,
Power input requirements ........... 12 VDC, 0.4 A for both transmitter and
Each transmitter and receiver can be powered locally by an
N
external power supply. The receiver can be powered remotely by
a power supply connected to the transmitter on the other end of
the CAT 5/5e/6/7 UTP or STP cable.
Temperature/humidity ................ Storage: -40 to +158 °F (-40 to +70 °C)/
connector
RJ-45 jack
RJ-45 jack
connector
3=GND
external; to 12 VDC, 2 A, regulated
receiver
10% to 90% noncondensing
Operating: +32 to +122 °F (0 to +50 °C)/
10% to 90% noncondensing
DVI DL 201 Tx/Rx • Reference Information A-3