Rack Mounting Procedures - Extron electronics Dual Link DVI Transmitter and Receiver DVI DL 201 Rx User Manual

Rack mounting procedures

The unit can be mounted in the front or rear of:
• RSU 126 (6" deep 1U universal rack shelf kit: PN
• RSB 126 (6" deep 1U basic rack shelf: PN
• RSU 129 (9.5" deep 1U universal rack shelf kit: PN
• RSB 129 (9.5" deep 1U basic rack shelf: PN
To mount the unit, follow these instructions:
1. Remove rubber feet if these have been installed on the
bottom of the unit.
2. Align the unit on the shelf and secure it to the shelf with
two 4-40 x 3/16" screws in diagonally opposite corners (see
the figure below, which shows installation using the
RSU 129 shelf).
HalfRackVersaToolsStandardShelf
3. Install false faceplate(s) or other unit(s) to the rack shelf.
4. Attach the shelf to the rack with the four provided
10-32 x 3/4" bolts
Front false
faceplate
uses 2
screws.
Use 2 mounting holes on
opposite corners.
Installing the DVI DL 201 Tx on a rack shelf
1U Universal Rack Shelf
DVI DL 201 Tx/Rx • Installation
60-604-10)
60-604-01)
1/2 Rack Width Front False
Faceplate
(2) 4-40 x 3/16"
Screws
60-190-10)
60-190-01)
2-3