Control Pass-Through - Extron electronics Dual Link DVI Transmitter and Receiver DVI DL 201 Rx User Manual

Installation, cont'd

Control pass-through

The DVI DL 201 Tx/Rx cannot be
controlled by RS-232 or IR controls.
However, they are able to pass signals
from a control device to a remote device
that is controlled by those signals.
N
Use the three-pole, 3.5 mm captive
screw connector on the transmitter
to input RS-232 or IR signals from a
control device. Use the corresponding
connector on the receiver to pass signals
to the output display.
C
DVI DL 201 Tx/Rx • Installation
2-18
The RS-232 and IR
communications are via a
passive pass-through only;
the transmitter and receiver
neither generate nor respond
to these signals.
The ideal length of exposed wire in the stripping
process is 3/16" (5 mm). If longer than 3/16", the
exposed wires may touch, causing a short circuit.
If shorter than 3/16", the wires can be easily pulled
out even if tightly fastened.
Do not tin the wires. Tinned wire does not hold its
shape and comes loose over time.
Tx Rx
3/16" (5 mm)
MAX
Tx Rx
3-Pole
Captive Screw
Connector