Table of Contents
Advertisement
Digital Projection Ltd. Titan Laser WUXGA
Control connections
1. Trigger 1 & Trigger 2
The Trigger outputs are activated by one of the three
following conditions, as set in the Setup menu:
Screen trigger: can be connected to an
l
electrically operated screen, automatically
deploying the screen when the projector starts
up, and retracting the screen when the projector
shuts down.
Aspect ratio trigger: can be used to control
l
screen shuttering for different aspect ratios.
RS232 trigger: can be used to control the
l
screen or screen shuttering on receipt of an
RS232 command
2. HDBaseT/LAN
The projector's features can be controlled via a LAN
connection, using Digital Projection's Projector
Controller application or a terminal-emulation
program.
3. RS232
All of the projector's features can be controlled
l
via a serial connection, using commands
described in the Protocol Guide.
Use a straight-through cable to connect directly
l
to a computer.
4. Ethernet/ArtNet
This dedicated LAN connection can be used if HDBaseT/LAN is already being used for HDBaseT signal input.
5. Wired Remote
The remote control can be connected using a standard 3.5 mm mini jack cable (tip-ring-sleeve, or TRS).
Rev A January 2019
page 36
Control connections
SYNC OUT
SYNC IN
HDMI 3
HDMI 4
HDMI 1
HDMI 2
HDBaseT / LAN
TRIGGER
1
2
RS-232
1
2
3
3D SYNC IR
IN
SDI
OUT
Ethernet / Art-Net
WIRE REMOTE
4
5
Notes
For a list of all commands
used to control the
projector via LAN, see the
Protocol Guide (available
separately).
Only one remote
connection (RS232 or
LAN) should be used at
any one time.
With a LAN connection the
projector can serve a web
page offering status and
projector controls.
Trigger 1 and Trigger 2
are not available with
HDMI 3 and 4 inputs.
Projector Controller is
available for download,
free of charge, from the
Digital Projection website.
Connection Guide
Advertisement
Table of Contents
