Control Connections - Digital Projection M-Vision 18K Series Installation And Quick Start Manual

Digital Projection M-Vision Laser 18K Series

Control Connections

1
Trigger 1
Trigger 2
2
The Trigger outputs are activated by one of the three following conditions, as set in the
•
Screen trigger: can be connected to an electrically operated screen, automatically deploying the screen when the projector
starts up, and retracting the screen when the projector shuts down.
•
Aspect ratio trigger: can be used to control screen shuttering for diff erent aspect ratios.
•
RS232 trigger: can be used to control the screen or screen shuttering on receipt of an RS232 command
RS232
3
•
All of the projector's features can be controlled via a serial connection, using commands described in the Protocol Guide.
•
Use a straight-through cable to connect directly to a computer.
Wired Remote
4
The remote control can be connected using a standard 3.5 mm mini jack cable (tip-ring-sleeve, or TRS).
LAN
5
This dedicated LAN connection can be used if HDBaseT/LAN is already being used for HDBaseT signal input.
HDBaseT/LAN
6
The projector's features can be controlled via a LAN connection, using Digital Projection's Projector Controller application or a
terminal-emulation program.
1 2
TRIGGER 1 2 RS-232
4 5 6
Connection Guide
3

CONTROL CONNECTIONS

Setup
menu:
3D SYNC -
For a list of all commands used to
control the projector via LAN, see
the Protocol Guide.
Only one remote connection (RS232
or LAN) should be used at any one
time.
With a LAN connection the projector
can serve a web page off ering basic
projector controls.
Trigger 1 and Trigger 2 are not
available with HDMI 3 and 4 inputs.
Projector Controller is available for
download, free of charge, from the
Digital Projection website.
OUT
Notes
Rev D October 2019
page 29