Table of Contents
Advertisement
Digital Projection Ltd. Titan Laser WUXGA
Control connections
1. Trigger 1 & Trigger 2
The Trigger outputs are defined in the Setup menu.
Each ouput can be triggered by one of the following
conditions:
Screen trigger. A trigger output can be used to
l
control an electrically operated screen. The
screen will be automatically deployed when the
projector starts up and retracted when the
projector shuts down.
Aspect ratio trigger. A trigger output can be
l
used to control screen shuttering for different
aspect ratios.
RS232 trigger. A trigger output can be used to
l
control the screen or screen shuttering on
receipt of an RS232 command.
2. HDBaseT/LAN
The projector's features can be controlled via a LAN
connection, using Digital Projection's Projector
Controller application or a terminal-emulation
program.
3. RS232
All of the projector's features can be controlled via a
serial connection, using commands described in the
Protocol Guide.Use a straight-through cable to
connect directly to a computer.
4. Ethernet/ArtNet
This dedicated LAN connection can be used if HDBaseT/LAN is already being used for HDBaseT signal input.
5. Wired Remote
The remote control can be connected using a standard 3.5 mm mini jack cable (tip-ring-sleeve, or TRS).
Rev B September 2019
page 40
Control connections
SYNC OUT
SYNC IN
HDMI 3
HDMI 4
HDMI 1
HDMI 2
HDBaseT / LAN
TRIGGER
1
2
RS-232
1
2
3
3D SYNC IR
IN
SDI
OUT
Ethernet / Art-Net
WIRE REMOTE
4
5
Notes
For a list of all commands
used to control the
projector via LAN, see the
Protocol Guide (available
separately).
Only one remote
connection (RS232 or
LAN) should be used at
any one time.
With a LAN connection the
projector can serve a web
page offering status and
projector controls.
Trigger 1 and Trigger 2
are not available with
HDMI 3 and 4 inputs.
Projector Controller is
available for download,
free of charge, from the
Digital Projection website.
Connection Guide
Advertisement
Table of Contents
