Delta Modulon DPH Series User Manual page 189

(1) The status of the EMS 1000 (EnviroProbe) device (ID #) has been set as 'Enable'
(please refer to
UPS or the connection cable may be damaged.
(2) The ID # setting is wrong. Please refer to
At this time, the warning message 'The EMS 1000 ID # Communication Fail' shown in
UPS-1.1
MEASUREMENT
WARNING
2 Touch Panel Comm Loss
1 PFC#1 Fan Fault
2. After connection of the EMS 1000 (EnviroProbe) to the UPS, if you don't set the status
of the EMS 1000 (EnviroProbe) device (ID #) as 'Enable' (please refer to
), the information of the EMS 1000 (EnviroProbe) device (ID #) will not show on
the EMS screen.
If none of the status of the EMS 1000 (EnviroProbe) devices (ID #) is set as 'Enable'
(please refer to
UPS-1.1
MEASUREMENT
EMS
EMS
ID
SETUP MAINTENANCE
Warning
Log
), the EMS screen will show as follows.
SETUP MAINTENANCE
Title Temperature Humidity
7-29
7
), but the device (ID #) is not connected to the
2
LOG IN WARNING
Administrator
Solution
Please contact service personnel for more information.
Please contact service personnel for more information.
LOG IN EVENT LOG
Administrator
Normal Warning
DI1 DI2 DI3
LCD Display & Settings
.
10:15
Sep 25,2018
On-Line
1
10:15
Sep 25,2018
Standby
Alarm Off
DI4