Starting Komtrax Terminal Operations - Komatsu WA250-6 Shop Manual

120 Testing and adjusting, Part 2

Starting KOMTRAX terminal operations

Starting KOMTRAX terminal
operations
In the case where the KOMTRAX terminal has
already been installed at the plant before ship-
ment:
a Implement the following procedure in the case
where the KOMTRAX terminal has already
been installed at the plant before shipment (as
standard equipment).
1. Notification of model, part number, and
serial number
Notify the KOMTRAX operations administrator
of model, part number, and serial number.
2. Registration of machine
The KOMTRAX operations administrator shall
use a KOMTRAX client PC to register the
machine.
a Refer to "Manual for KOMTRAX opera-
tions administrator" for the procedure.
a Now the terminal is ready for use.
In the case where the KOMTRAX terminal is ret-
rofitted:
a When retrofitting the KOMTRAX terminal after
shipment (retro-fitted machine), follow the
steps below.
1. Station opening check in machine side
a Complete steps 3) to 5) within 60 sec-
onds. If 60 seconds or above elapsed,
begin with step 1) again.
1) Turn OFF the starting switch and then,
a f t e r m a k i n g s u r e 5 s e c o n d s h a v e
elapsed, proceed to the next step.
2) Visually check that two check connectors
are connected.
Check connector: CHK0
q
Check connector: CHK1
q
WA250, 250PZ-6
3) When about 3 to 5 seconds elapsed after
the starting switch was set to ACC, make
1
sure that the 7-segment indicator lamp
changes to hyphen "–" on the KOMTRAX
terminal.
4) Disconnect check connector 1, and wait
for about 3 to 5 seconds as it is.
a Ensure that the connector is discon-
nected.
5) Reconnect check connector 1, and wait
for about 3 to 5 seconds as it is.
a If the KOMTRAX terminal detects that
the connector was disconnected and
connected, the dot on the 7-segment
indicator lamp blinks a few times.
SEN03837-01
45
30-120