Tuning Flowchart - Delta Electronics AC Servo Drive ASDA-AB User Manual

21. The ratio of Load Inertia to Servo Motor Inertia (J_load /J_motor) cannot be shown in the display of
JOG parameter P4-05 operation. Please press MODE key twice continuously and the users can see
the ratio of Load Inertia to Servo Motor Inertia (J_load /J_motor). Then, execute JOG operation again,
press MODE key once and press SET key twice to view the display on the keypad. Check if the value
of J_load /J_motor is adjusted to a fixed value and displayed on the keypad after acceleration and
deceleration repeatedly.

5.6.1 Tuning Flowchart

Revision January 2009
Chapter 5 Trial Run and Tuning Procedure|ASDA-AB Series
5-15