New Holland TX62 Operator's Manual page 170

Code Error description
200 ''LEVEL PRINT FAILURE"
Electronics on levelling printed circuit not functioning.
201 ''LEVEL PRINT FAULT"
Electronic steering of the actuator output on the printed circuit not func-
tioning.
The levelling printed circuit continues its work using relays only, but it
will fail soon due to burned contacts.
202 ''LEVEL 2 END COURSE"
2 end-of-course sensors are detected at the same time.
203 ''LEVEL STILL AT END L"
Power is delivered to the actuator motor but the left end-of-course sen-
sor does not detect the expected action (departure of the levelling
movement).
204 ''LEVEL STILL AT END R"
Power is delivered to the actuator motor but the right end-of-course
sensor does not detect the expected action (departure of the levelling
movement).
205 ''LEVEL NOT ARRIVED L"
Power is delivered to the actuator motor for 30 seconds to lift left side
up and the end-of-course switch has not yet detected the levelling.
206 ''LEVEL NOT ARRIVED R"
Power is delivered to the actuator motor for 30 seconds to lift right side
up and the end-of-course switch has not yet detected the levelling.
207 ''NO LEVEL P. DIAGNOSE"
The serial diagnose line from the levelling module to the central box
is interrupted.
505 ''ROTARY SEPARATOR S. 0"
Rotary separator rpm sensor disconnected (open).
506 ''ROTARY SEPARATOR S. --"
Rotary separator rpm sensor shorted to ground.
507 ''ROTARY SEPARATOR S. +"
Rotary separator rpm sensor shorted to +12 Volt.
510 ''WALKER RPM SENSOR 0"
Straw walker rpm sensor disconnected (open).
511 ''WALKER RPM SENSOR --"
Straw walker rpm sensor shorted to ground.
512 ''WALKER RPM SENSOR +"
Straw walker rpm sensor shorted to +12 Volt.
SECTION 4
Importance
MEDIUM
MEDIUM
MEDIUM
MEDIUM
MEDIUM
MEDIUM
MEDIUM
MEDIUM
LOW
LOW
LOW
LOW
LOW
LOW
4-69