Table of Contents
Advertisement
5. Remove cotter pins H, pins J, the safety latch(es)
and washers from both cylinders.
CAUTION:
Be careful: the cylinder is heavy.
6. Remove the header drive belt K from drive pulley
L.
7. Unscrew bolt M and remove keys N and bracket
halves P on both sides.
8. Move the tractor slowly forward while slightly low-
ering the straw elevator on the tractor.
To attach the straw elevator to the combine, proceed
in reverse order, but make sure to rest the header
height sensor lever Q on roll R of the straw elevator.
IMPORTANT:
Avoid possible oil contamination by properly fit-
ting the blanking plugs into the hydraulic quick-
couplers.
29
30
31
SECTION 4
55010
55016
30214
4-23
Advertisement
Table of Contents
