Table of Contents
Advertisement
9. Reinstall the steering cylinder support J in the
correct position.
10. Reinstall the bolts in the tie rod.
Adjust the toe-in as described in the previous para-
graph.
Steering wheel stops -- Figure 66
The steering wheel stops are factory-set and should
normally not require further adjustment.
If, for any reason, the stops require adjustment, pro-
ceed as follows:
1. Turn bolt E completely in.
2. Rotate the steering wheel to the extreme left or
right-hand position so that the steering cylinder is
at the end of its stroke.
3. Retract the steering cylinder 2 mm.
4. Turn bolt E against the support and tighten the
lock nut.
5. Proceed in the same way on the opposite side.
Steering ball joints -- Figure 67
Check the steering ball joints of the steering axle
every 50 hours of operation for correct nut torque or
possible play.
If, for any reason, the steering ball joints were disas-
sembled, the nut torque should be as mentioned in
Figure 67.
66
67
SECTION 5
21117
43184
5-33
Advertisement
Table of Contents
